IP66 Hardwired Wallbox EV Charger 7.4kW Type 2 Wall Mounted Outdoor Charging Station

The ACH-QE07 hardwired variant converts the Q series platform into a permanent wall mounted charging station for households that want a fixed, tamper resistant installation. Instead of a removable CEE plug, the unit is hardwired into the property supply with a fixed 1.8m Type 2 cable, giving a clean and secure finish on a garage or exterior wall.

Because there is no exposed plug and socket, the hardwired model achieves an IP66 protection rating across the control box and cable entry, making it well suited to exposed and coastal locations. The same 2.8 inch LCD, adjustable 6A to 32A current control and app connectivity carry over, so owners keep full smart charging functionality in a permanent format.

• IP66 Permanent Protection: Hardwiring removes the socket interface, allowing the highest ingress protection in the range for exposed or coastal walls.
• 7.4kW Wall Mounted Output: Provides a steady 7.4kW for dependable overnight charging from a single phase supply.
• Fixed 1.8m Type 2 Cable: A captive cable eliminates connector loss and stops the lead being borrowed or misplaced.
• Tamper Resistant Design: Permanently wired power and a wall bracket discourage casual removal, an advantage in shared parking areas.
• Central Current Control: Set the charging current in 6A to 32A steps via the panel or app to match the installed circuit.
• Dual NTC Thermal Sensing: Temperature sensors monitor the connector and electronics to prevent overheating under sustained load.

This configuration suits family homes, apartment blocks and staff car parks where a dedicated charge point is preferred over a portable lead. Its sealed construction is a strong fit for coastal regions, uncovered driveways and other sites exposed to wind driven rain.

Each station is delivered in a reinforced carton with an EVA protective box and includes the charger, user manual, mounting bracket and screw pack. The set measures approximately 460 x 350 x 165mm and weighs 3.5KG.

Units are bench tested for insulation resistance, dielectric strength and full load charging before packing. The product holds TUV-Mark and CE certification and meets IEC 61851-1 and EN 18031 standards.